How to Flash Firmware to H100 Bacnet/IP Card

How to Flash Firmware to H100 Bacnet/IP Card


The process of flashing the firmware to your Bacnet/IP card only takes a few minutes once everything is set-up. In order to properly install the software there are a few things you will need:

  1.       Ethernet cable
  1.       H100 Bacnet/IP Card
  1.       Bin File
  1.      H100 VFD
  1.   Computer or Laptop

 

1.      Connect Ethernet card to H100 port and power on machine.

2.      Connect to default Ethernet site at http://192.168.0.10/




3.      When signing in use username Admin with password 0.

4.      Check the box saying you have read the terms and fully understand them.


5.      Once in go to the settings tab on the left side of the page and click Communication Module.



 6.      Enable Ethernet/IP and save. Confirm the reboot and sign back into the site.


7.      Once Ethernet is enabled go to Communication Module Information and click Update Communication Module.


 



8.      Insert the proper bin file for the firmware update. 

9.  Wait for firmware to be flashed on to Ethernet card.



10. If successful a reboot will be requested. If not a red box will appear letting you know that the file did not load properly.


11. After the reboot double check the firmware is correct by navigating back to the Communication Module Information section.