H100 Ethernet Parameters are not correct
When setting up an H100 with a Dual Port Ethernet IP card you may notice some parameters
are different or missing based on the manual. See below examples.
- All IP, subnet, and gateway parameters defaulted to 0. While the manuals states it should be 192.168.1.
- COM 18, 19, 20, 21, 22 are present but do not match
the manual.
- COM23, 24, 25 are missing.
This can occur on older firmware for the H100 VFD. Check CNF10 and verify that is it 1.22 or higher. If you have an older version please contact LS Electric America technical support for assistance.